38" Tank Brush

I bought this to clean out my ball lock kegs, While it is plenty long to reach the bottom, I wish it was wider. The diameter is a couple of inches less than the interior of the keg. This makes it hard to use since you have to press it against the side, and the handle just bends.

It is a brush, it just seems like a lot of money for what you get, but it does the job. Ideally for the keg you'll want something with a bigger diameter.

This is quite an extensive brush, but it is also quite large. Since the handle is so long the handle bends a bit as you use it. What I used before this was one of those dish scrubbing sponges with the long handle. This makes it easier to get down to the bottom of the kettle, but the sponge felt more sturdy. I marked this brush down because I think there are better ways to spend your $13 on this website.

Its a long and wide brush that is able to get to depths that shorter brushed can't. But the stem isn't that thick so you can't apply much pressure or it will bend. It's good but not great. The only alternative is to reach way in with a shorter but thicker stemmed brush.

This is a big brush and can cover the entire inside of the keg. It bends a little when you get it all the way in, too bad it's not a little sturdier. But it's still very good and a lot better than reaching in with a scrubber.