Call Us Toll-Free 888.449.2739

Cooler Kit Basic Gott / Rubbermaid Conversion Kit - Brass No Barb

$24.99

Product Number: ZY50

Availability: In stock

These innovative products are the highest quality available. All you need is a 7/8" drill bit. "Why pay a welder?" BrewLogic's entry level Gott/ Rubbermaid fitting is anything but basic. The stainless steel bulkhead fitting provides a watertight seal, and a 1/2" NPT port for attaching a quick disconnect fitting or 1/2" NPT barb on the outside of the cooler, or a 12" Boil Screen or 1/2" NPT barb on the inside of the kettle. The attached ball valve is brass.

Customer Reviews

9 People have reviewed this product

Overall Rating: 4.3

Add Your Review
Set Ascending Direction

Easy to attach Review by Fontack

(Posted on 2/28/14)

Product Rating:

I have a rubbermaid cooler and this took little effort to attach. Use some Teflon tape and maybe another washer and you wont have leaks.

No leaks Review by Huber

(Posted on 11/26/13)

Product Rating:

I converted my Rubbermaid cooler with it. It was simple and I haven't had any leaks.

Easy instillation on a rubbermaid cooler Review by Sam

(Posted on 3/18/13)

Product Rating:

I recommend adding Teflon tape to the threads on the outside of the cooler. I had a small leak, but once I added more Teflon tape it stopped leaking. Overall it works fine.

Multiple leak tests and some frustration but it works Review by Calmncents

(Posted on 1/28/13)

Product Rating:

My ten gallon igloo was troublesome. I needed another washer and lots of teflon tape. I'll probably make one from the hardware store next time.

good quality Review by Lonnie

(Posted on 11/23/12)

Product Rating:

I ended up not being able to use half of the pieces in this with my cooler, which was frustrating, but the pieces were al high quality. A little pricey.

Pretty Good Review by Brandon

(Posted on 11/22/12)

Product Rating:

Easy to install and works fine, just make sure you use enough Teflon tape. I used it on a 10 gallon Rubbermaid cooler.

Great for DIY Review by Adam

(Posted on 11/15/12)

Product Rating:

This kit works great for those who want to take control of their All Grain setup. Use this with a rubbermaid cooler to turn it into a mashtun with very little dead space. Very easy installation.

Great Product Review by Hophead73

(Posted on 5/26/12)

Product Rating:

Installed onto a 5gallon Rubbermaid round cooler. Easy instillation. Definitely recommend adding more teflon tape to the threads on the outside of the cooler. Had a small leak, but once I added more teflon it sealed up perfectly.

Good product Review by QauckBoom

(Posted on 11/6/10)

Product Rating:

Installed two of these in 10 gallon and 5 gallon round Rubbermaid coolers. They went in perfectly the first time with no leaks and no fuss. Good installation instructions included with the assemblies.

Set Ascending Direction
Cooler Kit Basic Gott / Rubbermaid Conversion Kit - Brass No Barb