DetailsThese innovative products are the highest quality available. All you need is a 7/8" drill bit. "Why pay a welder?" BrewLogic's entry level Gott/ Rubbermaid fitting is anything but basic. The stainless steel bulkhead fitting provides a watertight seal, and a 1/2" NPT port for attaching a quick disconnect fitting or 1/2" NPT barb on the outside of the cooler, or a 12" Boil Screen or 1/2" NPT barb on the inside of the kettle. The attached ball valve is brass.
Proposition 65 Warning for California Consumers: This product contains chemicals known to the State of California to cause cancer and/or birth defects or other reproductive harm.
- Details & Instructions
4.5 / 5.010 ReviewsJanuary 7, 2016Easy to attachI have a rubbermaid cooler and this took little effort to attach. Use some Teflon tape and maybe another washer and you wont have leaks.February 28, 2014No leaksI converted my Rubbermaid cooler with it. It was simple and I haven't had any leaks.November 26, 2013Easy instillation on a rubbermaid coolerI recommend adding Teflon tape to the threads on the outside of the cooler. I had a small leak, but once I added more Teflon tape it stopped leaking. Overall it works fine.March 18, 2013Multiple leak tests and some frustration but it worksMy ten gallon igloo was troublesome. I needed another washer and lots of teflon tape. I'll probably make one from the hardware store next time.January 28, 2013good qualityI ended up not being able to use half of the pieces in this with my cooler, which was frustrating, but the pieces were al high quality. A little pricey.November 23, 2012Pretty GoodEasy to install and works fine, just make sure you use enough Teflon tape. I used it on a 10 gallon Rubbermaid cooler.November 22, 2012Great for DIYThis kit works great for those who want to take control of their All Grain setup. Use this with a rubbermaid cooler to turn it into a mashtun with very little dead space. Very easy installation.November 15, 2012Great ProductInstalled onto a 5gallon Rubbermaid round cooler. Easy instillation. Definitely recommend adding more teflon tape to the threads on the outside of the cooler. Had a small leak, but once I added more teflon it sealed up perfectly.May 26, 2012Good productInstalled two of these in 10 gallon and 5 gallon round Rubbermaid coolers. They went in perfectly the first time with no leaks and no fuss. Good installation instructions included with the assemblies.November 6, 2010
- Customer Q&A