DetailsThe gas in dip tube will work with Cornelius/ Firestone kegs. It is made from stainless steel so you won't have to worry about it affecting your beer.
- Details & Instructions
4.4 / 5.05 ReviewsWatch out, Some Kegs this size is to big.The refurbished keg i purchased from here needed some replacement parts such as the dip in tube and this one did not fit. It was interesting, the keg came with a strange orange plastic dip tube gas in, I wish i wouldn't have tossed it because i'm searching for a replacement! Doublecheck your gear!April 12, 2013Just like OEMIf you happen to damage this part on your keg or lose it, this is a great replacement part. Works and fits just like the OEM one. Also, don't forget to put the washer back on it.December 13, 2013Good overall purchaseI purchased two of these dip tubes for use in a couple of Firestone Pin Lock kegs that I picked up a couple of years ago that were missing them. I give them a 4 star rating for the following reasons: I have seen them a little cheaper; but I can do "one stop shopping here". They are a little shorter that the ones that are in my other kegs; but I can't imagine that will matter. They came with o-rings. The o-rings are a little larger than what I am used to (although I am unsure if the ones that I am currently using are "correct" although they work fine. I am glad I ordered some extra o-rings as I think that these may need to be replaced on a regular basis due to the fact that they are large and may develop tears and or abrasions from installation of the fitting. I suppose for the cost of replacement o-rings, they should be replaced every time anyways.February 14, 2013won't work in some firestone kegsWon't work in firestone keg with plastic tubesMarch 12, 2013Just like OemLittle expensive for what it is but it does work, I used them to replace the units on my Spartanburg challenger VI 3 gallon kegs. They were Identical.March 20, 2013
- Customer Q&A
Browse 3 questions Browse 3 questions and 5 answerswhere is this located in keg? what is its purpose? new to kegging.BEST ANSWER: This tube goes on the inlet side or gas side. Ideally it should only fit on one side of the keg. There should also be an o-ring with this or make sure you have one. Finally be sure to use some kind of food safe lubricant on the o-ring to help prevent any leaks.What are the dimensions?BEST ANSWER: I have no idea. It's in the keg undder pressure. Sorry.These are different than what is presently in the Mini Cannonball kegs. Are these the replacement part for the Mini Cannonball Kegs?