DetailsThe FastFerment spigot allows you to pull samples for tasting or checking gravity during fermentation. Simply drill a hole in your FastFerment Conical Fermenter (using the included drill bit) and install the spigot.
Kit Includes: Spigot, drill bit, & instructions for installation.
- Details & Instructions
4.5 / 5.02 ReviewsWorks like a champ!I sure wish I had one of these years ago...I'd have a lot more usable buckets if I did.April 17, 2017Purchased
11 months agoInstructions for locating the spigot hole lacked sufficient detail. I had to contact FastFerment for clarification. I also used a Roybi power drill at low rpm rather than a socket wrench as suggested.May 23, 2017Purchased
10 months ago
- Customer Q&A
Browse 3 questions Browse 3 questions and 9 answersWhat size is the drill hole needed? and can I buy the spigot lone.BEST ANSWER: You will need to drill a 1 inch hole. You can most definitely purchase the spigot alone. Here is the link to that spigot. http://www.midwestsupplies.com/fermenter-s-favoritestm-bottling-spigot.html I hope that this helps!Is this drill bit for plastic only or can it be used for metal or glass?BEST ANSWER: This is a tungsten coated step bit suitable for drilling holes into most materials.
Drilling plastic with this bit is sort of like taking a 50 BMG to a knife fight.
However, much like the BMG, I do not think it will drill holes into glass without shattering it.Where is the best place to drill the hole?BEST ANSWER: It comes with instructions but I would go about 1/2 to an inch higher. Otherwise it seems your pull too much trub out when getting a sample.