DetailsThe Weldless Bulkhead Fitting is perfect for creating a port to add a 1/2" NPT Thermometer, or if you already have a ball valve that you want to add to your kettle or sanke keg. This is a stainless steel Bulkhead with a brass lock nut. It comes with high temp washers to create a watertight seal. Requires a 7/8" hole for mounting. Use a 7/8" drill bit to drill your hole.
- Details & Instructions
4.0 / 5.016 ReviewsJust GreatProduct fits and works perfectly. The order, processing , and delivery was quick. Thank you Midwest Supplies.February 11, 2018Purchased
11 months agoWorks well enoughIt's made of good quality materials. I wish it had good instructions. Use threaded tape and try it without the ORing.April 5, 2014Took me some time to get it to workOnce I realized that the washer side o-ring wasn't necessary it was much, much easier to install. I was worried at first that it was defective, but it's good._x000D_It's worked a-Ok since and hasn't leaked.February 20, 2014Got it to workAt first it leaked then I put some threaded tape on the nipple - problem solved._x000D_Some clear directions would be appreciated.January 8, 2014It worked out okI read the reviews here and took off the extra O-ring and had no problems.November 11, 2013good productIt's made of good quality stainless steel with good O-rings. But the instuctions are lacking and the washer is loose on the nipple and almost too large for the coupling. With some experimentation I got it to work fine.September 27, 2013Remove the O-ring on the washer side and it worksIt works as it should provided you remove the O-ring on the washer side. Otherwise it will leak. Its a big plus that it's stainless.August 17, 2013Pretty goodThe components are good and it's easy to install. I read about the O-ring on the washer side, so didn't use it, and have had no leaks.July 22, 2013It works okI had problems at first until I removed the O-Ring on the washer side. Now it's fine. I took off a star for the hassle. It's made of good components and I think it will stand the test of time.June 20, 2013Requires some patience to get it to workIt's made of good quality materials. The washer is loose fitting and I couldn't figure out how to make it sight. Then I tried it without an O ring and it it tight. Good instructions would have helped.April 6, 2013
- Customer Q&A