DetailsThe Stainless 1/2" MPT (Male Pipe Thread) x 1/2" Barb works well with the Kewler and Weld-B-Gone kits, or the Blichmann 1/2" stainless ball valve. Makes attaching 1/2" tubing to your equipment easy with the use of one of these barbs.
- Details & Instructions
4.5 / 5.08 ReviewsUseful for your March pump fittingsI have used these with the polypropylene extensions for my March pump. These fittings can be tightened down hard in the extensions. That way the PPL extensions don't damage the pump housing threads as much. Great for all kinds of connctions !! easy to clean!!November 18, 2012Works great for systemsThis hose barb works great for brewery systems as it is 1/2". This size allows the greatest flow rate with minimal complications for your system.January 10, 2013SS braid in coolerI use this product to connect my braid to my T in my mash tun. They are easy connect to with the braid with hose clips. Highly recommend for the DIY mash tun enthusiast.April 1, 2013GoodGreat addition to my brewpot will worth the price.April 19, 2013Great productSolid construction means you can crank down hard on this and it won't break. I suggest heating the tube under hot water so it goes on easier. Don't forget a washer on the other end.September 24, 2013For the Blichmann ball valveIf you have a Boilermaker, you need one of these to connect to a hose to get your wort into the fermentorOctober 25, 2012Great for ball valveHave one of these attached to the ball valve on my brew keggles. Works great, might want to consider throwing a hose clamp over the hose if you are draining hot wort out as the tubing can soften and loosen due to the heat, but that is more of an issue with using the correct tubing than this barb.January 9, 2013Did not fit the Blichmann Ball valve very wellI have a 10 gallon pot and it only screwed into the ball valve about half way. I didn't want to force it further with a wrench. It doesn't leak, so I guess it's ok.November 22, 2012
- Customer Q&A