DetailsUse these in conjunction with a chrome plated hex or wing nut when attaching to a keg coupling or shank.The MFL thread gives you a quick disconnect option for use in conjunction with our 1/4" FFL barbed swivel nuts. This tail piece works well for interchanging between ball lock and Sanke keg couplings.
- Details & Instructions
4.9 / 5.010 ReviewsAwesome for switching back and forth between commercial and homebrewI am just getting started into kegging and these little things are awesome. I replaced the barbs on the sankey tap with these things. Then placed female fittings on the end of my liquid and gas hoses. Now I can switch back and forth between my ball lock disconnects and sankey tap until production gets going.December 12, 2012Convert your Sanke to MFL quick connectsThis does the trick, allowing quick connection to either a commercial Sanke or Corny keg after replacing the barbs on the Sanke gas and beer lines. No need to replace line connections to convert.January 31, 2013Great productThese are great! They allow you to connect a standard coupler to your gas/liquid hoses. This makes it really easy to swap between corny keg disconnects and a standard keg coupler.February 22, 2013A Kegging MustThese make switching lines so much simpler than the standard tailpiece and a must have for me.April 15, 2013Great for switchingI put these on my snake keg and leave them. Great for switch in a 6th barrel.August 17, 2013Exactly What I Needed!This is perfect for connecting a store bought keg to an existing ball lock setup. Just take the ball lock off the line and attach this adapter. Don't forget to add the nut and washer.September 18, 2013Great for SankeyI use these in place of the barbed tail pieces. These are great because you can use a swivel nut to change from Sankey to Ball lock keg connections.September 20, 2013Adapts a Commercial Keg Coupler to Home KeggingGet 2 of these for every commercial keg coupler you are adapting for use in a home kegging system (assuming that your end fittings are all 1/4" female flare to accomodate pin / ball lock fittings as well). Use in conjunction with a neoprene washer & hex nut (although your coupler probably came with these). Doesn't work with the low-profile sanke keg coupler.December 1, 2013Switching is easy (get the neoprene washer too)I leave them on my Sanke keg. Makes it easy to switch around to ball locks._x000D_February 27, 2014Work Okay but need gasketThese work well for making the swap between ball lock threaded barbs and sankey keg. But do yourself a favor and get Neoprene Washer 5108 it was a huge pita to get the slow leaks to stop on the co2 lines.April 23, 2013
- Customer Q&A