DetailsCreate a tap handle of your very own and mount it with this easy to use Brass Dual Threaded Insert. Drill a 1/2" hole 5/8" deep in the bottom of your wooden piece, and screw the insert into the hole. You've now set your faucet up with a custom tap handle!
Proposition 65 Warning for California Consumers: This product contains chemicals known to the State of California to cause cancer and/or birth defects or other reproductive harm.
- Details & Instructions
5.0 / 5.09 ReviewsYou can make a handle out of anythingThis little item allows you to make your tap handle out of basically anything you wish.February 27, 2014love how easy it is to uselove these bought a few easily turned old yeast vials into taps that i filled with grain or hops_x000D_ helps make cheap unique homemade tap handlesFebruary 16, 2014needs 9/16" holeI got these and they are working great, but I had to drill a 9/16" hole instead of the 1/2" hole they recommend. When I tried to get them in the 1/2" hole, the tap handle was cracking, but a 9/16" hole worked perfectly. That larger hole also allows you to push (with some pressure) the insert partially into your hole to get it going straight easier.June 6, 2013Good product with 2 small issues for installation.I had two small issues with the inserts. First the lead threads needed to be filed to remove some burrs left over from machining. Secondly in hard oak I could not get the insert started with the recommended 1/2 inch hole and so I had to drill a 9/16 inch one to get them to thread into the handle.March 26, 2013Great dealCan't beat the price and if you want custom handles than this is a must.March 14, 2013Great cheap solution for custom handlesMy neighbor has a small lathe and he made me two handles, one was out of some cherry and one was out of walnut. He used wax on the threads when tapping the handle to lubricate the wood and it worked out well.February 6, 2013Did the jobOrdered several of these and 2-3 of them had damaged threads, they filed right out though. Worked great on both wood and antler tap handles. I would recommend giving yourself some room to play with on the diameter of the base of your handle if you are turning your own (1/4") or like Lonnie said the handles will split.November 28, 2012Worked Well enoughThe first one I used cracked and broke as I was trying to screw it in. Also had a tough time getting it into the predrilled hole straight without cracking the wood. _x000D__x000D_The second one I used a drill to get it in straight and quick without cracking.October 30, 2012
- Customer Q&A
Browse 4 questions Browse 4 questions and 10 answersAre these standard size for all taps?BEST ANSWER: I have been using these threaded inserts in my homemade beer tap handles for quite some time and I have sole many all over the country. So yes, I believe you can say these would be the standard for all beer tap handles.Do you only get 1?BEST ANSWER: yes...only one. however, it's less expensive than the same insert on amazon ($4.99).With the item #K215 insert - what is the thread size inside the insert?BEST ANSWER: 3/8" x 16 thread. This is a standard 3/8 inch bolt size and the size on any beer faucet handle. I turn my own handles on the lathe and insert these in a hole drilled in the end. You can use a screwdriver but I finally bought a T-handle with the matching slot from Woodcraft which makes it easier to screw in the insert.Can you ship to New Zealand? Thanks