1/2" MPT x 1/2" Barb - Stainless

  • 1/2-inch MPT by 1/2-inch Barb

1/2" MPT x 1/2" Barb - Stainless

SKU P007

PRICE AS CONFIGURED:

$8.99

Product Details

The Stainless 1/2" MPT (Male Pipe Thread) x 1/2" Barb allows you to connect 3/8" or 1/2" ID tubing to the IsoFlow® Kettle Valve Kit or any ball valve with 1/2" NPT fittings.

California Proposition 65

⚠ Proposition 65 Warning: This product contains chemicals known to the State of California to cause cancer and/or birth defects or other reproductive harm.

Additional Information

SKU P007

Customer Reviews

Based on 8 reviews
63%
(5)
25%
(2)
13%
(1)
0%
(0)
0%
(0)
M
Matt
Great product

Solid construction means you can crank down hard on this and it won't break. I suggest heating the tube under hot water so it goes on easier. Don't forget a washer on the other end.

s
shogan
Good

Great addition to my brewpot will worth the price.

a
alexander
SS braid in cooler

I use this product to connect my braid to my T in my mash tun. They are easy connect to with the braid with hose clips. Highly recommend for the DIY mash tun enthusiast.

A
Adam
Works great for systems

This hose barb works great for brewery systems as it is 1/2". This size allows the greatest flow rate with minimal complications for your system.

t
tim
Great for ball valve

Have one of these attached to the ball valve on my brew keggles. Works great, might want to consider throwing a hose clamp over the hose if you are draining hot wort out as the tubing can soften and loosen due to the heat, but that is more of an issue with using the correct tubing than this barb.

12

Customer Reviews

Based on 8 reviews
63%
(5)
25%
(2)
13%
(1)
0%
(0)
0%
(0)
M
Matt
Great product

Solid construction means you can crank down hard on this and it won't break. I suggest heating the tube under hot water so it goes on easier. Don't forget a washer on the other end.

s
shogan
Good

Great addition to my brewpot will worth the price.

a
alexander
SS braid in cooler

I use this product to connect my braid to my T in my mash tun. They are easy connect to with the braid with hose clips. Highly recommend for the DIY mash tun enthusiast.

A
Adam
Works great for systems

This hose barb works great for brewery systems as it is 1/2". This size allows the greatest flow rate with minimal complications for your system.

t
tim
Great for ball valve

Have one of these attached to the ball valve on my brew keggles. Works great, might want to consider throwing a hose clamp over the hose if you are draining hot wort out as the tubing can soften and loosen due to the heat, but that is more of an issue with using the correct tubing than this barb.

12