DetailsA damaged keg post can make it difficult or impossible to attach post connects. Post attaches to the beverage out threaded port of the keg. Liquid Ball Lock Quick Disconnects will fit these posts. All keg posts come complete with poppet valves.
- Details & Instructions
5.0 / 5.04 Reviewsgreatreasonable cost, high quality and prompt deliveryJanuary 18, 2019Purchased
5 months agoNice replacement partGood quality and easily replaces the existing one on the keg. However if you need both of these plus other parts it might be less money to buy a new keg.October 2, 2013Converting pin lock to ball lockI bought this to convert an older pin lock keg to ball lock. It fit just fine but unfortunately it did not create a seal on the liquid dip tube. When I tried to run beer from this keg through a inline filter, this caused it to draw in co2 from inside the keg through the filter. This was ok but just caused it to take a lot longer to filterMay 20, 2013bought one for beer line cleanerI bought this to attach to my pond pump/beer line cleaning machine so when I clean my beer lines, I can attach the liquid line directly to my pump and clean away. Works like a charm!February 20, 2013
- Customer Q&A
Browse 2 questions Browse 2 questions and 3 answerswhat size wrench us used to change this? Does the 7/8 wrench fit or the smaller one 11/16 wrenchBEST ANSWER: I’m not sure which size socket would be used for that post. I can’t tell by looking at it.Are these threads 9/16-18?BEST ANSWER: No, the threads on "Cornelius" brand soda kegs are 19/32", a thread size seen no place else. The "Firestone/Spartanburg" kegs use the 9/16" threading. Make sure you know which brand keg you have before ordering replacement parts for it! -Mike W, Midwest Supplies