1/4" MFL to 3/8" Barb

  • 1/4" MFL to 3/8" Barb

1/4" MFL to 3/8" Barb

SKU S6018

PRICE AS CONFIGURED:

$4.29

Product Details

The all stainless 1/4" MFL (Male Flare Thread) to 3/8" Barb piece is useful for connecting tubing with female flared fittings (barbed swivel nuts) to 3/8" tubing.

California Proposition 65

⚠ Proposition 65 Warning: This product contains chemicals known to the State of California to cause cancer and/or birth defects or other reproductive harm.

Additional Information

SKU S6018

Customer Reviews

Based on 3 reviews
67%
(2)
33%
(1)
0%
(0)
0%
(0)
0%
(0)
A
Adam
Works Well

I use this 3/8" barb for my automatic line cleaning setup. My hoses for my setup use 3/8" hose and then I can connect directly to my 1/4" mfl keg lines.

C
Christopher
Reviewing: 1/4" MFL to 3/8" Barb

Works as advertised. I did use some Teflon tape to ensure a good seal. I am using this to provide CO 2 for my portable Kegerator. (2 3-gallon kegs inside of a cooler.)_x000D_Anyways I would most definitely and by this again if I needed another one._x000D_

J
Jesse
Works for 1/4" connections

Had to purchase this item with the 3/8" barb even though the liquid side of my kegging system (and most others?) uses 1/4" ID tubing. You can make it fit after lots of expletives, sweat, and sore fingers! Not sure why it's so difficult to find a 1/4" barb in these types of fittings, am I the only one?_x000D__x000D_Note: I found it easier to push the 3/8" barb into 1/4" line by screwing a female beer thread fitting onto the threaded side to help push through and to use food safe keg lube on the barb side.

Customer Reviews

Based on 3 reviews
67%
(2)
33%
(1)
0%
(0)
0%
(0)
0%
(0)
A
Adam
Works Well

I use this 3/8" barb for my automatic line cleaning setup. My hoses for my setup use 3/8" hose and then I can connect directly to my 1/4" mfl keg lines.

C
Christopher
Reviewing: 1/4" MFL to 3/8" Barb

Works as advertised. I did use some Teflon tape to ensure a good seal. I am using this to provide CO 2 for my portable Kegerator. (2 3-gallon kegs inside of a cooler.)_x000D_Anyways I would most definitely and by this again if I needed another one._x000D_

J
Jesse
Works for 1/4" connections

Had to purchase this item with the 3/8" barb even though the liquid side of my kegging system (and most others?) uses 1/4" ID tubing. You can make it fit after lots of expletives, sweat, and sore fingers! Not sure why it's so difficult to find a 1/4" barb in these types of fittings, am I the only one?_x000D__x000D_Note: I found it easier to push the 3/8" barb into 1/4" line by screwing a female beer thread fitting onto the threaded side to help push through and to use food safe keg lube on the barb side.