Faster to set up than a silver bullet. Helps your beer leap tall brew rigs in a single bound. This is the pump connector kit that you need to take your brew pump to the next level. Everything you need to make your brewing pump quick to set up and quick to take apart on brew day so that you can get back to what is really important - drinking...um, we mean brewing.
Works with Steelhead Pumps, March Pump 809, March Pump 815, Chugger Pump, or any other brew pumps with 1/2 NPT threaded inlets and outlets.
Cut the thermoplastic tubing to the custom lengths you need for your all grain equipment or brew kettles. The use of Female Disconnects on the tubing ensures easier operation of the disconnect itself, preventing burns from hot equipment.
Many don't realize you can control the flow of a magnetic-drive pump from the outlet. The stainless-steel ball valve allows for precise flow control during a transfer or while filling your fermenter, without the need to invest in an expensive variable-speed pump. You can even cut the flow entirely with the valve while leaving the pump running. That way your pump doesn't lose its prime.
The easiest way to get your new brewing pump setup.
- 1/2“ Stainless Ball Valve 1x
- Male Stainless Quick Disconnect X Female 1/2" NPT1x
- 9 Feet 1/2“ ID Thermoplastic Tubing 1x
- Teflon Pipe Thread Tape - 30” 1x
- Female Stainless Quick Disconnect 1/2” Barb 4x
- Male Stainless Quick Disconnect 1/2” NPT 3x
- Worm Gear Clamp 4x
**Pump Not Included**