DetailsThis is just the Wye Splitter fitting. It does not come with any shutoff valves or check valves. It has two 1/4" NPT female ports and one 1/4" NPT male port.
Proposition 65 Warning for California Consumers: This product contains chemicals known to the State of California to cause cancer and/or birth defects or other reproductive harm.
- Details & Instructions
4.5 / 5.04 Reviews2 keg one reg setup.This works great for my two keg one regulator setup and the price was fair also.April 28, 2017Purchased
over 2 years agoWorks!This solid hunk of brass has been milled down to the great basic unit you see here! Probably the cheapest way to expand your gas system and just like any fitting remember to use thread tape! I always go the extra setup and dunk the finished pressurized unit in a rubber maid filled with water to make sure there isn't even the smallest of leaks. Some times you will be surprised with what you find!April 4, 2013perfect for splitting an air lineI used this to put into my dual pressure regulator: one regulator is used for force carbing, and the other regulator has this splitter for drinking pressure for 2 kegs. I have 3 kegs on a dual regulator = awesome._x000D__x000D_If you are using this for a regulator, be sure to buy an additional ball check valve to attach the line to. You'll need another (the regulator already has one that you can use- this splitter replaces it's spot)March 15, 2013Easy way to split gas lineCheapest way to split a gas line. I used for running the beer gun and keg off of the same tank. The manifolds work nicely too, but this is quick and cheap if you quickly need 2 lines from 1 CO2 tank.February 4, 2013
- Customer Q&A
Browse 2 questions Browse 2 questions and 6 answersCan you use this to split the gas line for a nitro system?BEST ANSWER: I used it to run 2 co2 lines off of a single manifold, I'm sure it would do as well for nitro. If you're thinking of using it in an either or situation you would have to use caution not to have both open at the same time.What type of thread sealant was used on this brass to stainless joint?BEST ANSWER: This fitting is all brass. You would use a standard good quality thread tape for connection of like or different materials. Just avoid copper/sweat/solder with brewing equipment for chemical safety.